| Characteristics | A
solvent free, water soluble thinable wall paint, made of natural raw materials.
Its coating is shining and breathable, high in coverage, diffusible, fast
drying, wash and scrub resistant with a neutral scent. |
| Ingredients | Linseed Oil, Turkey
Red Oil, Casein, Boron Salt, Cellulose, Bergamot oil, talcum, chalk, titanium-dioxide
and lithopone. |
| Application | For the application
on sustainable undergrounds in interior areas like plaster, concrete,
gas concrete, gypsum plaster boards, cellulose fibre board as well as
ingrain wallpaper. Also utilised for the renovation of old, commercial,
synthetic emulsion paint, that are free of dirt and dust. Used as primer
for BIOFA Wood Varnishes. |
| Preliminary treatment |
Surface has to be dry, sustainable and clean. Remove all remains of lime-paint and glue-bound distempers. Clean off or roughen up enamel paint and oil coatings. Sandy as well high absorbent undergrounds need to be primed with our solvent free Sealing Primer 0810 (1:3 thinned with water) before Durasol 3006 can be applied. Surfaces with lower absorbency should be primed with Sealing Primer 0810 (1:1 thinned with water) as well. Wait at least 6 weeks before treating new concrete, lime and cement rendering. For wallpapered undergrounds, where wallpaper has been removed, the surface needs to be lightly roughened (sandpaper grade 60 - 100). Remove dust (use brush or vacuum and wipe with a wet cloth) or clean thoroughly using a brush and hot water. After 24 hours drying duration prime underground using thinned solvent free Sealing Primer 0810. Wallpaper paste remainders are possible to cause problems with the adhesion. Important notice:
It is possible that different substances like lignin, nicotine, rust,
different salts etc. can be carried through to the surface by moisture,
causing discoloration and differences in colour tones, due to the treatment
of several undergrounds with watery and porous coating systems. Therefore
preliminary tests must be done. |
| Colour Tones |
Durasol 3006 can be toned with Color Concentrates 3510 - 3590. |
| Processing |
Stir throughly. You may mix paint with 5% water for the primary coating. On new ingrain wallpaper or surfaces light in color it is sufficient to apply one full, undiluted coating. Apply by rolling or brushing or use an Airless-Sprayer (Spray nozzel 0.53 mm, air pressure 200 bar). Do not process when temperature is below 5°C. Important! Make
sure to ventilate well when working with the product and while it is
drying! |
| Drying | You can apply next
coating after approximately 2 hours drying duration. Drying duration is
about 24 hours (20 - 23°C / 50 - 55% rel. air moisture) when applying
the glazing technique. |
| Coverage | Usage
120ml/m². Coverage 8-9m²/ltr. Usage as well as the coverage depend on
the absorbency of the underground. |
| Cleaning of implements |
Clean
implements immediately after use with water and NAPONA 2090. |
| Storage | Seal tight and keep in a cool
place. Make sure paint does not receive frost. Use up open containers
as fast as possibile. Storage life is about 1 year when kept properly. |
| Containers | 4
lt / 10 lt containers |
| Safety precautions |
Even natural paint should not be disposed in waste water. Keep out of reach of children. The raw materials
used can cause a smell that is typical of the product! |
| Disposal | Clean out containers
and bring them to the recycling centre. Dried-out remains and rags can
be discarded with the other domestic waste. |